Please take care to disassemble your original microphone to see what the capsule inside looks like. The large-diaphragm capsule needs 48V phantom power supply, which needs to be matched with the circuit board. If the circuit board of your original microphone is a small diaphragm or mid-diaphragm on the market, it does not support this capsule.

The gold-plated layer of this large-diaphragm capsule is plated on the film with a purity of 99.99% gold wire. Only the gold-plated film with high purity can have a high degree of sound reproduction, making the sound delicate and natural, and the frequency response wide.

The steps to replace the capsule are as follows:

1. When replacing a new capsule, do not touch the front and rear diaphragms of the capsule with your hands; do not twist the connection screws on the capsule; handle gently, and hold the copper plate on the side with your thumb and index finger.

2. First install the sound head firmly on the bracket or in the rubber sleeve (the gold-plated surface is the front side, that is, the side where the person is singing); then directly weld the thread with the line on the sound head. Do not turn any screw on the sound head.

3. According to the welding point of the original sound head, the wire on the gold-plated surface is the positive electrode; when the wire is soldered with a soldering iron, false welding or virtual welding is not allowed.

4. After the installation is complete, please tighten all the enclosures before testing; when you are talking or singing, do not blow into the sound head, wear the microphone blowout cover when using it, and pay attention to moisture at ordinary times.

5. To achieve the sound, please re-adjust the sound card, such as reverberation, treble and bass, etc.